Undermount Drawer Slides

Material Choices: Steel
Weight Capacity: 75 lb to 155 lb
Extension: Full
Full Extension: Drawer box will pull out of the cabinet, and the back of the drawer box will be even with the face of the cabinet.



Helpful Information:

***All of the requirements for this type slide should be considered before the drawer box is purchased or built.***

Undermount slides have very specific allowance requirements.
Make sure to check the spec sheet for the slide chosen.

The width of the drawer will depend on slide chosen and the side-to-side clearance needed for that slide. Side-to-side allowances range from 3/8" overall to 1/2" overall, depending on series chosen.

Depth of the drawer should match the slide chosen. (I.e., If you choose an 18” drawer slide, the drawer box will have to 18” deep also, and so on.)

This type slide also has specific height allowances.

Note: Blum Tandem drawer slides in this category can be used with the Tip-On touch latch system and the Servo-Drive electronic drawer opening system. Ask an associate for information.

CabinetParts.com associates are available to answer any questions you might have. Feel free to contact us at 800-857-8721, or by Skype or LiveChat.



Installing:

Instructions are provided or can be found on each product’s details page.



What you will need:

Tape measure, screwdriver, battery-powered or electric screw gun, and a carpenter's square.

Category: Tips | Drawer Slides |