Shelf Hardware Standards and Brackets Standards and Brackets by U.S. Futaba
Loading from Primary Photo

32 mm Universal Bracket, Zinc

Our Item Number FUT-72531-04-093

For the assembly of cabinet components, as well as the installation of shelves and rear panels. They are suitable for flush and butt fitting assemblies. By hooking them onto the screws, facia boards, etc., can be installed in situations where screw mounting is difficult or almost impossible. Use #8 or #10 panhead screws

$
1.90 Each
$0.95/ea for 300
$2.53
SAVE 25%
Ends Sep 10
Product Info Product Finish: Zinc, See more product details
Qty:       Each
  or  
PRO Packs ™
Save more! Buy a Pro Pack.

 

Large Project?

Orders $2500+ Qualify for Special Discounts.

Build your item list and get a Quick Quote

view bid cart
Compare this item

All the product info you could ask for...

  • Manufacturer Info

  • Manufacturer : U.S. Futaba
  • Manufacturer Part # : 72531 04 093
  • Manufacturer Finish : Zinc

  • Other Important Info

  • Product Type : Misc. Fastener
  • Product Finish : Zinc

  • Manufacturer Resources

Back to Top
back to top

Reviews about our customers experience

"These reviews are from our Customers who have purchased these products."
  • 5 of 5 | September 2nd, 2026

    On time delivery. Soft close drawer glides work as expected.

  • 5 of 5 | September 2nd, 2026

    We had a shipping issue, the box was damaged causing two of the slides to also be damaged. The customer service representatives we spoke to were fantastic. They were extremely helpful and resolved the issue quickly. We really enjoyed working with them.

  • 5 of 5 | September 2nd, 2026

    i was advised correctly and professionally on the pieces i needed for my kitchen cabinets.

  • 5 of 5 | August 31st, 2026

    Ordered 86 locks and they all came with no issues in a timely fashion...

  • 4 of 5 | August 31st, 2026

    The drawer boxes are very well made and fit perfectly. But the holes in the back are slightly oversized, and I had to fill them with a bit of hot glue at assembly to make it work. Not a big deal, but should probably be drilled 6 mm instead of 1/4" .

See More Reviews
Back to Top
back to top
×