I ordered some of these, just in case, but did not need them for my project. They apparently provide a hole for the rear hook on a shelf that is too thin to drill the hole in the shelf. These come singly, so if you need them, order two for each pair of drawer slides.

Was this review helpful? yes no

Worked perfect

Was this review helpful? yes no

I purchased 6 pairs of 15" Progressa+ drawer slides for a walnut dresser. Of the 12 slides, 5 were assembled incorrectly at the factory. This review page does not support attaching pictures, but basically the geared mechanism was assembled incorectly. On the 5 bad slides, the gears were off from 1/4" to over 1/2". The intended use was for inset drawers, and it's not feasable to have one side of the drawer to be 1/4" to 1/2" shorter than the other. I was able to disassemble the slide, re-align the internals and re-attach the geared slider to bring the slides into correct position using a 'good' slide as a reference. The quality of the slides is actually very good, just the assembly in the factory was bad. More troubling is that I've reported this on the Salice customer feedback site over a week ago, and have not had any response at all.

This review is about similar Salice Drawer Slides. (SH-G5U6S381XXF6)

Was this review helpful? yes no

These are simple, only allowing adjustment for the drawer height. They come in a pair (left & right) to match a pair of the drawer slides.

This review is about similar Salice Drawer Slides. (SH-421.23.000)

Was this review helpful? yes no

These slides work great for my application, where I had an oddly shaped drawer and had to mount one of the slides a few inches in from the edge of the drawer. The slides were fairly easy to install, they work smoothly, and allow full extension of the drawers.

This review is about similar Salice Drawer Slides. (SH-A65559/60)

Was this review helpful? yes no